Trunking - Waters Network Systems ProSwitch FlexPort- 2600M Installation Manual And Operating Manual

Managed modular copper and fiber switch

Hide thumbs Also See for ProSwitch FlexPort- 2600M:

Table of Contents

6.13

Trunking

This switch supports three trunk connections which are disabled by default.

Follow these steps to configure trunking:

1. Select Enable in the Trunk Function section of the screen.

2. Click Apply to enable the function.

3. Use Trunk 1 or Trunk 2 to create a trunk of the 10/100Mbps ports.

4. Use Trunk 3 to create a trunk for the Gigabit ports.

5. Click Apply to save the settings.

6. If you want to disable the trunk function, select Disable and click Apply. The switch will

clear the Trunk configuration.

Note: The trunk connection supports the redundant function. If a trunk cable is broken, the

traffic going through that cable will be transferred to another trunk cable in the trunk

connection automatically.

WATERS NETWORK SYSTEMS™

6.15 – Protected Port Setting

6.16 – Trunk Settings

ProSwitch

2600M, User's Manual, 02/07

Page 42

Table of Contents