Protected Port Configuration - Waters Network Systems ProSwitch FlexPort- 2600M Installation Manual And Operating Manual

Managed modular copper and fiber switch

Hide thumbs Also See for ProSwitch FlexPort- 2600M:

Table of Contents

6.14 – Port Authentication Configuration

6.12

Protected Port Configuration

The Protected Port function allows you to isolate the traffic between protected ports. For

example, if Ports 1, 2 and 3 are marked as protected, the traffic between these three ports

will be blocked, even they are in the same VLAN. However, they still can communicate with

other ports in the same VLAN. This function adds another level of security to the switch.

1. Select Enable.

2. Click Apply in the Protected Function section of the screen.

3. Select the ports that should be isolated from each other and click Apply.

4. If you want to choose all ports, click on Select All. Remove all can be used at a later

time to remove the protection from all of the ports

WATERS NETWORK SYSTEMS™

ProSwitch

2600M, User's Manual, 02/07

Page 41

Table of Contents