Waters Network Systems ProSwitch FlexPort- 2600M Installation Manual And Operating Manual page 19
Managed modular copper and fiber switch
Hide thumbs
Also See for ProSwitch FlexPort- 2600M:
- Installation manual and operating manual (39 pages)
Table of Contents
Advertisement
Command
Description
isolated ports in the same VLAN.
pvlan
Set members of port-based VLAN
groups
Note: If a port does not belong to any
VLAN, that port will be isolated from
other ports – including the internal
management interface of the switch
qos
Set QoS configuration
The switch supports four priority
queues on each port – P0, P1, P2
and P3. Both port-based priority and
802.1P tag priority are supported.
This command can be used to
configure the QoS setting of the
switch.
rate control
Set rate control configuration
This command is used to set the
maximum traffic rate to/from
connection ports of the switch.
WATERS NETWORK SYSTEMS™
Syntax
set pvlan [1:enable|0:disable]
set pvlan name [vlan#] [vlan
name] – Ex. Set pvlan name 1
vlan_1 - sets the name of VLAN 1
as vlan_1
set pvlan [+/-][port#][vlan#] – Ex.
Set pvlan +1+2+3+4+5-7 1 – add
ports 1, 2, 3, 4 and 5 to VLAN1
and remove port 7 form VLAN1
set qos enable command
This command is used to enable
QoS operation.
set qos disable command
This command is used to disable
QoS operation.
set qos priority command
This command is used to
configure port-based priority. All
packets coming from high priority
ports will always be forwarded to
the highest priority queue P3. All
packets coming from a low
priority port will always be
forwarded to the lowest priority
queue P0. For example, "set qos
priority 3 high" command will set
Port 3 as a high priority port.
set qos dot1p command
This sub-command is used to
enable/disable the 802.1P QoS
operation for each connection
port.
dot1p 3 on" will enable the
802.1P QoS operation at Port 3.
If a tagged packet comes to Port
3, it will be forwarded with the
priority setting in its tag.
set qos mapping command
This command is used to map the
802.1P priority 0~7 to the four
priority queues. For example,
"set qos mapping 3 1" command
will map the 802.1P tag priority 3
to priority queue P1 and packets
with tag priority 3 will be
forwarded to priority queue P1 of
egress port.
set ratecontrol drop
[0:disable|1:enable]
Set packets drop for ingress limit
set ratecontrol [ingress|egress]
®
-
ProSwitch
2600M, User's Manual, 02/07
For example, "set qos
Page 17
Advertisement
Table of Contents
