Waters Network Systems ProSwitch FlexPort- 2600M Installation Manual And Operating Manual page 22
Managed modular copper and fiber switch
Hide thumbs
Also See for ProSwitch FlexPort- 2600M:
- Installation manual and operating manual (39 pages)
Table of Contents
Advertisement
Command
Description
Additional Information :
Settings for set sta port :
stormcontrol
Set storm control configuration
This switch supports broadcast and
flooding storm control functions.
set stormcontrol rate
subcommand is used to set the
maximum storm rate that is allowed
WATERS NETWORK SYSTEMS™
hello (0~65535): the period to
send the spanning tree
maintenance packet if the switch
is the root of the spanning tree.
Default is 2 seconds.
age (6~40): the spanning tree
aging time if no spanning tree
maintenance packet is received.
It will cause the spanning tree to
re-create. Default is 20 seconds.
delay (4~30): the maximum
waiting time before changing
states (i.e., listening to learning to
forwarding). This delay is
required because every device
must receive information about
topology changes before it begins
to forward frames. In addition,
each port needs time to listen for
conflicting information that would
make it return to a blocking state;
otherwise, temporary data loops
.
might result
cost (1~65535): It is used to
determine the best path between
devices if looping occurs. Lower
values will be forwarded and
should be assigned to ports with
fast connections. Higher values
will be blocked and should be
assigned to ports with slow
connections. The suggestion
values are 100(50~600) for 10M,
19(10~60) for 100M and 4(3~10)
for 1000M connections.
priority (0~255): If the path cost
for all ports on a switch are the
same, the port with the highest
priority (lowest value) will be
forwarded when looping happens.
If more than one port has the
same highest priority, the port
with lowest port number will be
forwarded.
: this
ProSwitch
Syntax
age - set bridge maximum age
delay - set bridge forward delay
time
set sta port is used to configure
for ports of the switch
Syntax: set sta port [port#]
[cost=xxxx] [priority=xxxx]
set stormcontrol
rate - set suppression rate for
storm control
bc – set broadcast control for
each port
fd – set flooding control for each
®
-
2600M, User's Manual, 02/07
Page 20
Advertisement
Table of Contents
