hit counter code

Waters Network Systems ProSwitch FlexPort- 2600M Installation Manual And Operating Manual page 15

Managed modular copper and fiber switch
Hide thumbs Also See for ProSwitch FlexPort- 2600M:
Table of Contents

Advertisement

Command
Description
default is 300
Additional information: Disable aging is different from static MAC ID in ARL table. The
connection port is fixed for a static MAC ID, but the connection port could be changed for a
MAC ID with no aging.
arl
Add a static MAC address in the ARL
table
Additional Information: Set ARL 00-00-01-11-22-33 5 will add a static MAC ID 00-00-01-
11-22-33 to port 5 and this MAC ID will never be aged out from port 5.
Note: Because the static MAC address is fixed on the assigned port by the switch, the
static MAC address can access network through the assigned port only. It will fail to access
the network through other ports of the switch.
automode
Set auto negotiation or auto detect
mode of the port
When a port is forced to some special setting instead of full auto-negotiation, this command
can be used. There are two modes: an (autonegotiation) and ad (auto detection)
an mode – if the auto function of a port is disabled in the port configuration, the switch will
disable its auto-negotiation function; the auto-MDIX function of the port is also disabled.
That is the real force-mode setting of the port.
ad mode – if the auto. function of a port is disabled in port configuration, the switch will not
disable its auto-negotiation function but just modify its auto-negotiation attribute for the
speed/duplex mode setting; the Auto-MDIX function of the port is still enabled.
Application: If the connected device is auto-negotiation enabled and you want to force the
speed of the connection (for example, 10M/Half), select ad mode. If the connected device
is in forced mode (for example, 10M/Half) and auto-negotiation is disabled, use an mode
and set the port to the same configuration as the device in the port configuration function.
You can select an mode or ad mode depending on your applications. For most connection
cases, ad mode is suggested. For 100FX connection, it is recommended to use an mode
and disable Auto. Set the port to 100/Full.
dot1x
Set 802.1x configuration
WATERS NETWORK SYSTEMS™
enable – set 802.1x to enable
eisable – set 802.1x to disable
authmode – set 802.1x auth
mode of a specified port
authport – set authenticate port
of radius server
quiettime – set 802.1x quiet
timeout period
re_au – set 802.1x re-
authentication
reauthcnt – set 802.1x re-
authentication max count
reauthtime – set 802.1x re-
authentication timeout period
reqcnt – set 802.1x max request
count
rspi – set radius server address
shkey – set 802.1x shared key
ProSwitch
Syntax
Set ARL [xx-xx-xx-xx-xx-xx]
[port#]
set automode
Ex: set dot1x enable
®
-
2600M, User's Manual, 02/07
Page 13

Advertisement

Table of Contents
loading

Table of Contents