To Write Protect Or Un-Protect A Configuration - HP StoreOnce 2700 Installation And Configuration Manual
Backup system
Hide thumbs
Also See for StoreOnce 2700:
- Installation and configuration manual (127 pages) ,
- Service and maintenance manual (60 pages) ,
- Service and maintenance manual (81 pages)
Table of Contents
Advertisement
2.
In the Port set section, click Add.
3.
Enter Port Set details, in exactly the same way as when creating a new configuration.
Select the required 1 Gbit or 10 Gbit ports. Available ports are active for selection; ports
already assigned are greyed out.
If multiple ports have been selected, select a Bond Mode, as appropriate. This should be
Mode 1 or Mode 4 for VLAN.
4.
Be sure to check the VLAN Tagging Enable box and click OK.
5.
In the Subnet section, click Add.
6.
Enter Subnet details, in exactly the same way as when creating a new configuration, and be
sure to add the VLAN tag ID. Click OK.
7.
Save and validate the changes. If required, you can also activate the configuration at this
point.
To write protect or un-protect a configuration
Select the configuration in the Custom Network Configuration list and click Edit.
Click in the Protected checkbox to change its status and click Save.
Repeat this process to switch the status back to Un-protected.
58
Network configuration, how to use the StoreOnce GUI
- Quick Links:
- Hp Storeonce 2900, 2700, 4500 and...
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
