Completing The Installation; Setting Up Time And Date - HP StoreOnce 2700 Installation And Configuration Manual
Backup system
Hide thumbs
Also See for StoreOnce 2700:
- Installation and configuration manual (127 pages) ,
- Service and maintenance manual (60 pages) ,
- Service and maintenance manual (81 pages)
Table of Contents
Advertisement
8 Completing the installation
This chapter describes common tasks required after installation.
Set the time and date and NTP server, if this was not done as part of the system set
config wizard. See also
Apply any licenses for additional capacity, replication, StoreOnce Catalyst or Security features,
if required. See
Discover and add storage for any expansion shelves that have been added, see
storage (page
Understand how to access the StoreOnce Backup system over SFTP, see
StoreOnce Backup system over SFTP (page
Install any software and firmware updates, if needed. See
Configure Remote Support. See
Configure SNMP, if required. See
Perform a configuration save. See
Reset the password for the HPresetpassword account and save the new password securely
offline. See
For other tasks, such as user account configuration, email configuration, and device configuration
for backup/replication targets using VTL, NAS or StoreOnce Catalyst refer to the HP StoreOnce
Backup system user guide.
Setting up time and date
NOTE:
HP strongly recommends setting the time and date when configuring the network using
the system set config wizard. This section describes how to do this if you have not used the
wizard.
1.
Open the puTTy (or other ssh) application and log into the StoreOnce CLI.
2.
Make sure you know what the UTC time is and then set the system clock using the following
command:
time set utc <mm/dd/yyyy hh:mm:ss>
TIP:
If defining an NTP server, still set UTC because this will result in a quick synchronization
with NTP.
3.
Set the time zone using the following command:
time set timezone
You will be asked to select a continent/ocean and country as part of the command sequence.
4.
If you have defined an NTP server, enter its IP address or FQDN using the StoreOnce CLI
command:
time add ntpserver <IP address or FQDN>
Setting up time and date (page
Configuring licenses (page
62).
Configuring Remote Support (page
Managing and resetting the password for the HPresetpassword account (page
60).
63).
Configuring SNMP (page
Saving configuration file (page
59).
Accessing the
Software update process (page
67).
74).
74).
Setting up time and date
Expanding
64).
75).
59
- Quick Links:
- Hp Storeonce 2900, 2700, 4500 and...
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
