Table of Contents
Advertisement
10. Remove the ICL board from the mounting bracket by removing the four mounting screws (1) as displayed
in the following figure.
1
1
Installing the ICL
Procedure
1. Install the replacement ICL board on the mounting bracket using the four mounting screws.
2. Install the ICL bracket using the three bracket mounting screws.
3. Install both controller modules. See Installing a controller module on page 57.
4. Install the enclosure cover and press the hood latch down to engage the latch.
5. Install the enclosure in the rack.
6. Tighten the front retaining screws.
CAUTION:
The front CTO retaining screws must be attached at all times when the enclosure is racked.
7. Reconnect all cables to the enclosure, including the power cables.
1
2
2
1
1
1
Installing the ICL
79
Hide quick links:
Advertisement
Table of Contents
