Table of Contents
Advertisement
Control Operator's Reference Manual
For example. let's assume that the over-the-air Control Op prefIX is A943. the
telephone Control Op prefIX is 4943. and root set.a is selected. These are
all
detennined by the repeater owner with programming commands.
The command to enable the repeater system over any of the command channels
except the telephone is
A943501
The command entered over the phone is
4943 501 #
If the "Unique Response Message" Command Acknowledge mode is selected. the
controller responds to the command with "Repeater Eft. In the "Generic
Response" mode. it responds with the programmable Control Op Response
Message, such as Udlt-dlt". If the "Response Off' mode is selected. there is no
response to the command.
Command Categories
Commands are deSCribed
in
Chapter 2
in
alphabetical order by major category.
including
• Access and Command Modes
• Alarm
• Control Operator Utilities
• Courtesy Tone Selection
• ID Selection and Preview
• Macro Sets
• Patch (Autopatch. Autodialers, Reverse Patch)
• Remote Base / Unks
• Repeater Timers
• Scheduler
• Speech Synthesizer
• Tail Messages
Chapter 3 provides a command summary with the actual root codes and response
messages for each command.
(Introduction)
1-4
8/87 V3
Advertisement
Table of Contents
