Table of Contents
Advertisement
Control Operator's Reference Manual
Manual Phone Patch
Phone Offhook (pick up the phone)
Phone Onhook (hang up the phone)
Purpose
These commands allow a Control Op to manually "pick up" or hang up the phone.
Remarks
Most patch activity is supervised by the controller. However,
a
Control Op has the
ability using these commands to manually go offhook and then pass Touch-Tone
digits directly through to the phone line to place
a
call. The Autopatch timers
do
apply to a call initiated
in
this way. The call is directed to Local Phone Line
# 1.
The Phone Onhook command may also be used to hang up the patch
in
case a
use~~selected
a Custom Hangup Code but forgot the code that he selected .
.&
WARNING
No long distance protection applies to calls placed
in
this way.
Microcomputer Reset
Purpose
This command causes the controller's microcomputer to perform a "warm start",
which is Similar to pushing the reset button.
Remarks
The controller resets to Macro Set #0. Unlike a power-up reset, time, mailbox,
and meter channel high/low infonnation are preserved. The reset command is
seldom used, but is available
in
case you're confused about the state the controller
is in.
Power High /
Low /
Interrogate
High Power
Low Power
Power Interrogate
Purpose
These commands operate the Power Amp control output from the controller.
Remarks
The Power Amp control output may be wired to circuitry to place an rf amp in or
out of the transmitter path.
The "high power" state results in the PA logic output to be on (logic low).
(Access and Command Modes)
2-10
8/87 V3
Advertisement
Table of Contents
