Kenwood KNA-G620T Installation Manual

Gps navigation system

Hide thumbs Also See for KNA-G620T:

Download this manual See also: Instruction Manual, Installation Manual

GPS NAVIGATION SYSTEM

KNA-G620T

Failure to avoid the following potentially hazardous situations could result in serious injury or ﬁ re.

Do not attempt to install or service the KNA-G620T by yourself. Installing or servicing the unit without training and experience in electronic

equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock or other hazards.

When extending ignition wires, battery wires, or ground wires, use automotive-grade wires or other wires with AWG 18 (0.75 mm

greater to prevent wire deterioration and damage to the wire coating.

If the unit starts to emit smoke or unusual odors, turn off the power immediately and consult your Kenwood dealer.

Keep small articles (like screws or batteries) out of the reach of children. If any such object is accidentally swallowed, consult a doctor

immediately.

Failure to avoid the following potentially hazardous situations may result in injury or property damage.

Be sure to ground the unit to the chassis of your vehicle.

Secure all wiring with cable clamps or electrical tape. Insulate unconnected wires, do not allow any bare wiring to remain exposed.

Do not let unconnected wires or terminals touch metal on the vehicle or anything else that can conduct electricity.

Do not open the top or bottom covers of the unit.

The KNA-G620T is not waterproof.

January 2010

INSTALLATION MANUAL

B54-4791-08

WARNING

CAUTION

Part Number 190-01160-02 Rev. A

gauge) or

Printed in Taiwan

Page 1 Failure to avoid the following potentially hazardous situations could result in serious injury or ﬁ re. Do not attempt to install or service the KNA-G620T by yourself. Installing or servicing the unit without training and experience in electronic equipment and automotive accessories may be dangerous and could expose you to the risk of electric shock or other hazards.
Page 2 What’s Included GPS antenna and main unit M3 x 12 machine M3 x 12 thread- wiring harness metal plate screws (4) forming screws (4) M3 nuts (4) hook-and-loop owner’s manual installation manual warranty card caution card FM antenna fasteners (2) Installing the Main Unit Use the screws or the hook-and-loop fasteners provided to mount the main unit in the vehicle.
Page 3 - 3 -...
Page 4 Acquiring GPS Signals The ﬁ rst time you turn on the KNA-G620T, you must wait while the system acquires satellite signals for the ﬁ rst time. This process could take up to several minutes. Ensure that your vehicle is outdoors in an open area, away from tall buildings and trees, for fastest acquisition.