Table of Contents
Advertisement
Chapter 4
[1]
[2]
F-4-101
4.3.2.5 Removing the Drive Unit
1) Disconnect all connectors from the finisher controller PCB [1].
2) Remove the 2 screws [2] and remove the finisher controller PCB together
with the mount [3].
[2]
[3]
[1]
F-4-102
3) Detach the timing belt [1].
[1]
F-4-103
4) Remove the 4 screws [1] and remove the drive unit [2].
[2]
[1]
F-4-104
4.3.2.6 Removing the Process Tray Unit
1) Remove the 2 screws [1] and remove the inlet guide [2].
4-14
0008-1023
[1]
0008-1025
F-4-105
2) Remove the 2 screws [1] and remove the process tray unit (right) [2] and
stay [3].
3) Remove the 2 screws [4] and remove the process tray unit (left) [5].
[4]
[5]
[4]
[1]
F-4-106
4.3.3 Feed Rollor
4.3.3.1 Removing the PCB Cover
1) Open the front cover [1] of the finisher.
2) Pull the lever [2] and draw out the finisher.
[3]
[2]
F-4-107
3) Remove the 2 screws [1] and detach the PCB cover [2].
[1]
[2]
F-4-108
4.3.3.2 Removing the Top Harness Cover
1) Remove the 3 screws [1], release the 2 hooks [2], and then detach the top
harness cover [3].
[2]
[1]
[1]
[2]
[3]
0008-1123
[1]
0008-1124
Advertisement
Table of Contents
