Table of Contents
Advertisement
[1]
[2]
F-4-46
2) Disconnect the 2 connectors [1] and then remove the harness from the up-
per cover [2].
F-4-47
3) Remove the 3 screws [1] and detach the upper cover [2].
[1]
F-4-48
4.2.3.4 Removing the Stapler Cover
1) Remove the screw [1] and detach the stapler cover [2].
[1]
[2]
F-4-49
4.2.3.5 Removing the Stapler
1) Remove the screw [1], disconnect 2 connectors [2], and then remove the
stapler [3].
[2]
[1]
[2]
[1]
[3]
[2]
F-4-50
4.2.4 Drive Unit
4.2.4.1 Removing the PCB Cover
1) Open the front cover [1] of the finisher.
2) Pull the lever [2] and draw out the finisher.
[3]
3) Remove the 2 screws [1] and detach the PCB cover [2].
[2]
0008-1030
4.2.4.2 Removing the Top Harness Cover
1) Remove the 3 screws [1], release the 2 hooks [2], and then detach the top
harness cover [3].
[2]
[3]
0008-1031
F-4-53
4.2.4.3 Removing the Upper Cover
1) Remove the screw [1] on the back of the finisher and detach the top cover
(rear) [2].
[1]
[2]
F-4-51
[1]
F-4-52
[1]
[1]
Chapter 4
0008-1010
0008-1011
0008-1012
4-7
Advertisement
Table of Contents
