Step 3: Access The System Card Bay - HP 9000 Series Instruction Manual
Hide thumbs
Also See for 9000 Series:
- Service manual (472 pages) ,
- Service information manual (225 pages) ,
- Owner's manual (214 pages)
Table of Contents
Advertisement
NOTE
NOTE
Installing and Configuring 10/100Base-TX/9000
Step 3: Access the System Card Bay
Step 3: Access the System Card Bay
The HP-PB 10/100Base-TX card is not for use on a personal computer
(PC).
If you installed the card before you installed the software, execute
shutdown (no -h option) and proceed to "Step 5: Attach the System to the
Network."
Follow the steps below to prepare the system for installation of
10/100Base-TX hardware. Refer to the documentation for your system
for detailed information about opening and closing the system and
locating the slots in the HP-PB backplane.
1. At the HP-UX prompt, execute the following command and wait for
the system to shutdown completely.
/etc/shutdown
Power off and unplug the system.
2. Observe antistatic precautions. Equalize any static charge on your
body and your computer by using a grounded wrist strap or by
touching the chassis of the computer frequently while you are
installing the card.
Handle the card by the edges and avoid touching the edge connector
and the components.
3. Open the system to gain access to the HP-PB backplane, if applicable.
4. On the HP-PB backplane, select the lowest empty HP-PB slot and
remove the slot cover.
5. Go to the next section, "Step 4: Install the 10/100Base-TX Card."
24
Download from Www.Somanuals.com. All Manuals Search And Download.
-h 0
Chapter 1
Advertisement
Table of Contents
Troubleshooting
