Table of Contents
Advertisement
How to cut the media in roll-to-roll mode
How to cut the media in roll-to-roll mode
Introduction
When the system is in roll-to-roll mode you can cut the media after a job is finished.
NOTE
You can only cut the media automatically when the media property [Compatible with the
embedded knife] equals [yes].
Procedure
1. Tap on the dynamic bar of the user panel.
The queue opens and the Cut icon is visible in the dynamic bar.
2. Tap on the Cut icon in the dynamic bar to cut the media automatically.
Result
For custom media, you can be requested to perform a manual cut. For more information, see
Make a manual cut on page
198
Chapter 4 - Use the printing system
294.
Advertisement
Table of Contents
