Pogo Connector; Turn Off The Computer. If You Are Unsure Whether The Computer Is Off Or In Hibernation, Turn The Computer On, And Then Shut It Down Through The Operating System; Disconnect The Power From The Computer By Unplugging The Power Cord From The Computer; Disconnect All External Devices From The Computer - HP Elite x2 1013 G3 Maintenance And Service Manual
Table of Contents
Advertisement
POGO connector
Description
POGO connector and cable
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the following components:
a.
Display panel (see
b.
Battery (see
Remove the POGO connector:
1.
Using a PH Type #0 Phillips screwdriver, remove the two Phillips M1.6×1.6 screws (1).
IMPORTANT:
2.
Disconnect the POGO cable from the ZIF connector on the system board (2).
3.
Peel the cable up to disengage the adhesive that secures it to the computer (3), and then remove the
cable/connector from the computer (4).
Reverse this procedure to replace the POGO connector.
Display panel on page
Battery on page
36)
Be sure to use the correct size screwdriver to avoid stripping the screw.
33)
Component replacement procedures
Spare part number
L31359-001
43
Hide quick links:
Advertisement
Table of Contents
