Cleaning the Dust Proof Glass
If the dust proof glass is dirty, print defects may occur on the print output. Follow the procedure described below to clean the
dust proof glass.
Open the front cover, holding both sides.
1
Remove the dust proof glass cleaner from the rear side of the front cover by
2
sliding it to the left side.
* Dust Proof Glass Cleaner
Hold the dust proof glass cleaner so that the pad on the tip is facing down, push
3
it back as far as it goes, and then slowly move it up and down.
Clean the four locations as shown below. There are marks on the main unit that indicate the
cleaning locations. Check these marks when cleaning the dust proof glass.
114
Basic Operation Guide: imageRUNNER ADVANCE (iRA) C5235, iRA C5240, iRA C5250, iRA C5255 - 04/2012
*