Table of Contents
Advertisement
STATus:OPERation:ENABle?
Parameters
Comments
STATus:OPERation[:EVENt]?
Parameters
Comments
STATus:OPERation:PSUMmary:CONDition?
Parameters
Comments
Returns the value of the OPERation Status Enable Register as a signed 16 bit integer.
None
•
The only defined bit is bit 9 which is the summary of the Data Available and
Edge Status for Ports 0, 1, 2, and 3. See Figure 3-1.
Returns the value of the OPERation Status Event Register as a signed 16 bit integer
and then clears the register to 0.
None
•
The only bit in the OPERation Status Register used by the HP E1459A is bit 9
(decimal weight 512) which contains the summary of the Operation Status Port
Register. This is a destructive read so that all register bits are cleared after the
read is executed.
•
*RST does not affect the contents of the Status Operation Event Register.
•
*CLS clears the contents of the Status Operation Event Register.
•
STAT:PRESet does not affect the contents of the Status Operation Event
Register but does disable reporting the summary of this register in the Status
Byte Register (STB?).
Returns the value of the OPERation Status Port Summary Condition Register as a
signed 16 bit integer.
None
•
Bits 0 through 3 reflect Data Available on Ports 0 through 3 respectively; bits 4
through 7 reflect edge events on Ports 0 through 3 respectively. See Figure 3-1.
•
Note: THis command does not clear the Port summary Condition Register. The
register is cleared only by removing the the condition itself. For example,
MEAS:DIG:DATA0 will clear Bit 0 if it was set.
•
*RST clears all Status Operation Port Conditions.
•
*CLS does not affect the contents of the Status Operation Port Register
Conditions.
•
The STAT:PRESet command does not affect the Status Operation Port Register
contents.
HP E1459A SCPI Command Reference
63
Advertisement
Table of Contents
