2 electrolux PRODUCT DESCRIPTION The control panel Lid handle Filter access cover Lever for moving the appliance Adjustable levelling feet CONTROL PANEL 1. Programme selector 2. Spin speed selector 3. Pushbuttons and their functions 4. Lights of cycle progress 5. “Start/Pause” pushbutton...
3 DISPENSER BOX Prewash Wash Softener (do not fill above the MAX symbol SAFETY INFORMATION Before the installation and use of the appli- • If the appliance has a child safety device, ance, carefully read the supplied instruc- we recommend you activate it.
4 electrolux • Always be careful when you move the • Use this appliance in a household only. appliance because it is heavy. Always • Obey the safety instructions on the deter- wear safety gloves. gent packaging. • Make sure that there is air circulation be- •...
5 Before turning your appliance on again, en- sure that it is installed in an area where the temperature will not fall below freezing. HOW TO RUN A WASH CYCLE? USING FOR THE FIRST TIME • Run an initial wash cycle at 90°C, without any washing but with deter- •...
6 electrolux first pause the appliance by pressing the lected programme, the “Start/Pause” pushbutton flashes red. “Start/Pause” pushbutton. After closing the lid again, press the “Start/Pause” “PREWASH” OPTION (PREWASH) pushbutton. The appliance runs a prewash at 30°C START OF THE PROGRAMME max.
7 PROGRAMMES TABLE Programme / Type of washing Load Possible options 5,5 kg Rinse hold, Night silence plus, Pre- Cottons (cold - 90°) : White or colour, wash, Daily, Super quick, Rinse plus, e.g. normally soiled work clothes, bed linen, Delay start table linen, body linen, towels.
8 electrolux CONSUMPTION VALUES The data of this table are approximate. Different causes can change the data: the quantity and type of laundry, the water and ambient temperature. Programmes Load Energy con- Water con- Approximate Remaining (kg) sumption sumption (li-...
9 WATER INLET FILTERS To clean, proceed as follows : OPERATING PROBLEMS Numerous checks were carried out on your refer to the sections below before contact- appliance before it left the factory. Howev- ing the after-sales service. er, should you notice a malfunction, please...
10 electrolux Problems Causes The wash cycle is much • the water inlet filters are dirty, too long: • the power or water supply has been cut off, • the motor overheating detector has been activated, • the water inlet temperature is lower than usual, •...
11 help prevent potential negative ous to others: cut off the power supply consequences for the environment and cable at the base of the appliance. human health, which could otherwise be PROTECTING THE ENVIRONMENT caused by inappropriate waste handling of this product.