Page 1
U s e r I n s t r u c t i o n s ESF 675 ANC 822 945 780 - 00 - 0801...
Page 2
Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for...
Safety Instructions The safety aspects of ELECTROLUX electrical appli- • Never place the dishwasher in operation if the ances comply with accepted technical standards and mains cable, water inlet or drain hose is damaged; the German Appliance Safety Law. Nevertheless, as or the control panel, work top or plinth area is a manufacturer we consider it our obligation to make damaged such that the inside of the appliance is...
Securing the door of the dishwasher This way you can ensure that children cannot open the door of the dishwasher: 1. There is a lever (1) on the left side of the door han- dle. You can secure the door against being opened unintentionally by pressing this lever to the back using a small screwdriver or the handle of a spoon.
Economical and Ecological Dishwash- • Only connect the dishwasher to the hot water sup- ply if your hot water is not electrically heated. • Ensure that the water softener is correctly adjusted. • Do not pre-rinse dishes under running water. •...
Appliance Features and Control Panel Rubber Seal for Con- necting Water Feed to the Upper Spray Arm Spray Arms Water Hardness Switch Container for Special Salt Container for Rinse Aid Container for Detergent Suction Opening for Rating Plate Filters Fan Assisted Drying...
Control panel Indicators Programme cycle indicator ON/OFF button Programme buttons Door release Air outlet for fan Button for start time handle assisted drying preselection ON/OFF button Å Button for start time preselection Programme buttons Programme cycle indicator • gives you information on any set starting time Pre Wash •...
Prior to using for the first time Prior to using for the first time, remove all the clips with which the dish racks are secured for transport. Then perform the following steps: 1. Adjust the water softener 2. Filling with Special Salt for the Water Softener 3.
Filling with Special Salt for the Water Softener Use only special salt for dishwashers. Never fill the salt container with any another type of salt (e.g. culinary salt) or dishwasher deter- gent. This would irreparably damage the water softener. Prior to filling with salt, please check each time that you really do have a packet of spe- cial salt in your hand.
Filling with Rinse Aid Rinse aid ensures that your dishes gleam and are free from spots, and that you glasses are clear. Use only branded rinse aid for dishwashers. Never fill the rinse aid container with any another substance (e.g. concentrated vine- gar).
In Daily Use • Is it necessary to refill with special salt or rinse aid? • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes • Start the wash programme Loading cutlery and dishes Sponges, household cloths and any object...
Loading Cutlery If they are placed in the cutlery basket, long, pointed items of cutlery are a hazard, par- ticularly to children (see Safety Instructions). They must therefore be laid horizontally in the upper basket. To ensure that all cutlery is efficiently washed and reached by the water you should: 1.
Loading Cups, Glasses and Coffee Services Arrange smaller, sensitive items in the lower rack and place long, pointed items of cutlery in the knife drawer. • Arrange plates and dishes offset on and under the folding cup racks so that washing water can reach all items.
Adjusting the Height of the Upper Basket Maximum Height of the Dishes in the Upper Rack Lower Rack With upper basket raised 22 cm 31 cm With upper basket lowered 24 cm 29 cm Type 1 The height of the basket can also be adjusted when it is loaded.
Filling with Detergent Only use dishwasher detergent. Fill with detergent: Prior to the start of a wash programme (not for the pre wash programme). The detergent is released into the wash water during the programme. Please observe the manufacturer's dosing and storage recommendations as stated on the detergent packaging.
Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Type of Dinner Service and Cooking Utensils Coffee Service and Dessert Dishes Dishes: In Addition: with delicate with non-temperature resistant dishes glasses Type of heavily normally...
Setting the dishwashing Setting or Changing the programme Start Delay Timer Å 1. Check that the crockery and cutlery in your dish- With the button , you can preprogramme the pro- washer are arranged so that the spray arm is not gramme start time in 2-hour steps from 2 to 12 hours obstructed.
Switching Off the Dish- washer When the wash programme is finished: 1. Press the ON/OFF button . Power indicator light goes out. Hot steam may escape if the door is opened immediately after the end of the programme. Therefore: 2. Open the door carefully. Emptying the Dishwasher •...
Care and Cleaning Do not under any circumstances use furni- ture care products or aggressive cleaners. • If necessary, clean the controls only with a soft cloth and pure warm water. • The spray arms do not need cleaning. • Occasionally check the internal containers, door seal, and water inlet for soiling, clean if necessary.
Cleaning the Panel To be able to clean the control panel of the dish- washer, it is possible to remove the Plexiglas cover from the control panel. Remove the Plexiglas Cover Pull the mains plug of the dishwasher out of the socket.
Replacing the Internal Light The inside of the dishwasher is lit by a high quality, low-voltage lamp. A defective lamp may be replaced only by a trained technician. Before beginning to work, pull the dish- washer power plug out of the socket. For safety reasons, the lamp is not accessible from the inside.
What to do, when ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call in cus- tomer service to resolve one of the malfunctions listed here, or rectify an error made in the operation of the appliance, the customer service engineer’s visit is not free of charge, even during the period of guar- antee.
The dishes are wet and dull. • Rinse aid was not used. • The rinse aid container is empty. There are streaks, milky spots or a bluish coating on glasses and dishes. • Decrease rinse aid dosing. There are dried water drops on the glasses and dishes.
Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test pro- gramme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme Normal 50 °C.
Page 26
Sample loading arrangement: Cutlery basket Some dishwasher models have cutlery baskets with- out a grid insert.
INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted to ensure that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of sur- rounding units extend the threaded feet by unscrewing : –...
Built-In Dishwasher (see enclosed installation instructions) Free-Standing Appliances can be set up as stand-alone without addi- tional installation. If the dishwasher is set up next to a cooker, a heat-insulating, non-flammable plate must be mounted between the dishwasher and the cooker, flush to the top edge of the work sur- face (depth 57.5 cm).
Connecting the Dishwasher Water Connection The dishwasher is fitted with safety devices that pre- vent the wash water returning into the drinking water system and comply with the applicable plumbing reg- ulations. • The dishwasher can be connected to cold and hot water supplies up to max.
Water drain Drain hose The drain hose must not be kinked, crushed or entangled. • Connecting the drain hose: – Maximum permitted height: 1 metre. – Minimum required height 30 cm above the lower edge of the machine. Extension hoses •...
Electrical connection In compliance with electric company techni- cal requirements for mains connections, hard-wired connections to the mains may only be made by approved electri-cians. When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local electricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.
Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher because there is no space for them behind the appli- ance. The example plumbing and electrical installation given below can only be regarded as a recommenda- tion;...
SERVICE In the section "What to do, if..." the most important sources of faults that you can rectify yourself are summarised. If, nevertheless, you call in customer service to resolve a problem listed in these instruction, or because of an error made in operating the appliance, the customer service engineer’s visit is not free of charge, even during the warranty period.