ENGLISH For Your Safety These warnings are provided in the interest of safety. You read them carefully before installing or MUST using the appliance. It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred, always ensure that the book is left with the appliance in order that the new owner can get to know the functions of the appliance and the relevant warnings During Operation...
Contents Description of the appliance ......3 Guide to Use the instructions Instruction for the User ........3 Cleaning and Maintenance ........ 4 The following symbols will be found in the text to guide you throughout the Instructions: Guarantee - After Sales Service......5 Technical Data ..........
If you cannot light the flame even after several attempts, check the "cap" (Fig. 1 lett. A) and the "crown" (Fig. 1 lett. B) are in the correct position. To put the flame out, turn the knob to the symbol . In the absence of electricity, ignition can occur without the electrical device;...
Guarantee - After Sales Service Original spare parts This appliance, before leaving the factory, has been tested and studied by many experts and specialists, in order to give you the best results. Any repair work which needs to be carried out should be done with the utmost care and attention.
Technical Data Gas Burner Rating This appliance complies with the following Ultra-Rapid Burner 4,0 kW Directives: Class 3 Appliance 73/23 - 90/683 (Low Voltage Directive); 89/336 (Electromagnetical Compatibility Directive); Setting Liquid Gas G30/G31 28 - 30 mbar 90/396 (Gas Appliances) Gas connection G 1/2"...
Electrical Connection The appliance is designed to be connected to 220 / 240 V monophase electricity supply. The connection must be carried out in compliance with the laws and regulations in force. Before the appliance is connected: 1. check that the main fuse and the domestic installation Neutral can support the load (see the rating label);...
Adaptation to different types of gas Town gas Replacing the burner injectors 1. Remove the pan supports. 2. Remove the burner's caps and crowns. 3. With a socket spanner 7 unscrew and remove the injectors (Fig. 6), and replace them with the ones required for the type of gas in use (see Table 2).
Building In Dimensions are given in millimetres These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. 8. Installation and assembly These hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig.
Possibilities for insertion Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig.11.