HP Integrity rx4640 Quick Start Manual
Console quick start
Hide thumbs
Also See for Integrity rx4640:
- Operation and maintenance manual (232 pages) ,
- User's & service manual (197 pages) ,
- Service manual (167 pages)
Advertisement
Quick Links
HP Integrity rx4640 and HP 9000 rp4410/4440
Use this quick start guide for a system that is set up and ready to connect to a host console. This information
can also be found in your server installation guide and in the HP Integrity and HP 9000 Integrated Lights-Out
Management Processor Operations Guide.
To connect to a host console, use one or more of the following ports:
•
Console/Remote/UPS port (RS-232). Use this port to access the iLO MP through the console.
•
iLO MP LAN port. Use this port to access the iLO MP through the LAN.
•
VGA port. Use the port to access a graphics console. You cannot access the iLO MP using this port.
Physical Access
Figure 1 lists ports and required connection components.
Figure 1
Server Ports and Connection Components
iLO MP LAN Port (10/100 LAN Cable)
Console/Remote/UPS Port (RS-232)
(M Cable & RS-232 DB-9F to DB-9F)
IMPORTANT Once you are physically connected, the next step is to configure the console. The following
sections provide high-level console configuration information. For detailed information on
configuring the console, see the server installation guide included with the server
documentation.
MPN: A9950-96009 A9950-96009
Console Quick Start
VGA Port
EFI Only/No iLO MP Access
1
Advertisement
Related Manuals for HP Integrity rx4640
Summary of Contents for HP Integrity rx4640
- Page 1 Console Quick Start HP Integrity rx4640 and HP 9000 rp4410/4440 Use this quick start guide for a system that is set up and ready to connect to a host console. This information can also be found in your server installation guide and in the HP Integrity and HP 9000 Integrated Lights-Out Management Processor Operations Guide.
- Page 2 Console Quick Start iLO MP LAN Though there are several methods to configuring the LAN, DHCP with DNS is the preferred method. DHCP with DNS comes preconfigured with default factory settings, including a default user account and password. By default, the iLO 2 MP LAN uses DHCP to retrieve a new LAN address for itself if the firmware version on the iLO 2 MP is E.03.15 or newer.