Panasonic MDF-U5312 Series Troubleshooting Manual

Also See for MDF-U5312 Series:

Operating instructions manual (35 pages)

Table of Contents

Contents

1 TROUBLE SHOOTING
2 Documents / Resources
- 2.1 Download manual

Panasonic MDF-U5312 Series Troubleshooting Manual

TROUBLE SHOOTING

If the unit malfunctions, check out the following before calling for service.

Malfunction	Check/Remedy
The chamber is not cooled at all	The circuit breaker of power source is active The voltage is too low. (In this case, call an electrician.) The power switch is not ON. The large amount of articles (load) is stored in the chamber at one time. The freezer is in defrost condition.
The cooling is poor	The ambient temperature is too high. The outer door is not closed firmly. The large amount of frost is built on the chamber wall. The air intake vent is blocked. The set temperature is not inputted properly. The freezer is in the direct sunlight. There is any heating source near the freezer. A rubber cap and insulation for the access port are not set correctly. You put too many unfrozen articles into the freezer compartment.
Noise	The freezer is not installed on the sturdy floor. The freezer is not leveled with the leveling feet. There is anything touching the frame. The freezer is in the status immediately after start up. The unit sometimes causes a noise when the chamber temperature is high due to the large load. The noise gets less and less accompanying with the cooling of the chamber.

warning Note:
If the malfunction is not eliminated after checking the above items, or the malfunction is not shown in the above table, contact our sales representative or agent.