Accurex XID Quick Start Manual
Mixed flow outdoor cover
Hide thumbs
Also See for XID:
- Manual (64 pages) ,
- Installation, operation and maintenance manual (2 pages)
Advertisement
Quick Links
Quick Start Guide
XID Mixed Flow Outdoor Cover
•
Outdoor Cover parts are shipped
separate from the fan and are
mounted in the field
•
This Quick Start Guide does not
replace the Installation Operation
Manual (IOM), refer to the IOM for
more information
Parts List
•
(1) Fan
•
Outdoor cover kit
(2) End caps
(2) Mullions (size 27-33 only)
Side panels
(2) Size 7-24
(4) Size 27-33
Top panel(s)
(1) Size 7-24
(2) Size 27-33
Hardware kit
(1) Size 7-22
(2) Size 24-33
(1) Conduit kit
•
(1) Disconnect switch (optional)
•
(1) Isolator kit (optional)
•
Liquid-tight conduit (supplied
by others)
Tools List
•
Impact driver
•
5/16 inch nut driver
•
C clamp locking pliers
Step 1 - Mount Unit to Structure
•
Place unit in desired location and mount to structure
(outdoor units are horizontal base mount only)
•
Isolation is recommended but not required, please use
isolation if ordered
Step 2 - Install Ductwork to Fan
•
Apply sealant to duct connections
•
Use holes on inlet and outlet to mount ductwork to fan
(hardware supplied by others)
•
Flexible duct connectors are recommended for
mounting to the inlet and outlet of the fan
•
Install fan with approximately three wheel diameters of
straight duct before and after the fan
Step 3 - Install End Caps
•
TAKE CARE NOT TO DAMAGE THE FOAM TAPE ON
END CAPS
•
With flanges away from the fan, align the half moon
cutouts on the end cap with screws on inlet or outlet
•
Use the provided self-tapping sheet metal screws to
fasten the end cap to the fan DO NOT OVER-TIGHTEN
•
Install remaining end cap on the opposite side using
provided self-tapping screws DO NOT OVER-TIGHTEN
Step 4 - Install Side Mullions (Sizes 27-33 only)
•
Install left and right side mullions using (2) self-tapping
sheet metal screws per side
BOTTOM
TOP
Advertisement
Related Manuals for Accurex XID
Summary of Contents for Accurex XID
- Page 1 Quick Start Guide XID Mixed Flow Outdoor Cover • Outdoor Cover parts are shipped • Install remaining end cap on the opposite side using separate from the fan and are provided self-tapping screws DO NOT OVER-TIGHTEN mounted in the field •...
- Page 2 Determine ideal location for disconnect switch Plug unused end cap hole • Install per disconnect manufacturer’s guidelines Plug unused FOAM TAPE end cap hole FOAM TAPE SIZE 7-16 486125 • Outdoor Cover, Rev. 2, April 2024 • Copyright © 2024 Accurex, LLC...