hit counter code
Download
Share
Print this page
ABB i-bus 6164 U-500 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. ABB Manuals
  4. Controller
  5. i-bus 6164 U-500
  6. Operating instructions manual
ABB i-bus 6164 U-500 Operating Instructions Manual

ABB i-bus 6164 U-500 Operating Instructions Manual

Eib heating actuator
Hide thumbs

Advertisement

Quick Links

Download this manual
73 - 1 - 6212
GB
26195
®
ABB i-bus
EIB
Heating Actuator
6164 U - 500
GJ B000 6151 A0168
for flush-mounted installation
D
GB
F
N L
E
I
S
Operating Instructions
only for authorized, skilled electricians
with EIB training

Advertisement

loading

Related Manuals for ABB i-bus 6164 U-500

Summary of Contents for ABB i-bus 6164 U-500

  • Page 1 73 - 1 - 6212 26195 ® ABB i-bus Heating Actuator 6164 U - 500 GJ B000 6151 A0168 for flush-mounted installation Operating Instructions only for authorized, skilled electricians with EIB training...

  • Page 2: Table Of Contents

    In case you do not have the data base or Technical Manual, please ask for it by contacting the respective agency in your country. All packing materials and devices of ABB have symbols and approval signs indicating suitability for an environmentally benign disposal.

  • Page 3: Important Instructions

    Important instructions When planning and erecting electrical systems the relevant standards and regulations applicable in the country where the equipment is set up and operated must be duly observed. Work on the 230V mains system and EIB bus must exclusively be performed by trained electrical personnel.
  • Page 4 Fig. 1 / Overall View...

  • Page 5: Product Description

    Connection to the EIB line is made via two permanently wired leads and one bus connecting terminal. The switching behavior can be parameterized using ® ETS2 (see Technical Manual of the ABB i-bus EIB and individual device windows of the EIBA Tool Software ETS2, Release 1.1 or higher).

  • Page 6: Technical Data

    Technical Data Power Supply via ABB i-bus ® Connections permanent leads with tin-coated wire ends stripped 10 mm 1 Bus connection via 2 connecting leads with bus connector terminal red/black, 0.8 mm conductor cross section appr. 90 mm long 2 Inputs...
  • Page 7 53 x 50 x 24 mm (H x W x D) Weight 0,08 kg More information is available with respect to the technical data listed above. Please consult the current Technical Manual of the ABB i-bus ® EIB as well as device windows of the ETS2 software.
  • Page 8 Fig.2 / Wiring Diagram...

  • Page 9: Mounting Instructions

    Mounting Instructions If the physical address has not yet been assigned, the programming key (Fig. 2) should remain accessible. Do not cut in the required 230-V power supply before all connections have been properly hooked up and insulated! The unit can be mounted in a cable duct with two combined wall and joint boxes (due to separation of low voltage and 230-V system).

  • Page 10: Mounting

    Mounting • Switch off the 230-V mains supply! • In the event the connecting leads have to be exten- ded: – Run these leads (max. 2.5 mm conductor cross section) into the interior of the mounting enclosure to be used (eg. flush-mounted double box). –...

  • Page 11: Commissioning

    Commissioning The relevant application versions available with pertinent parameters can be seen from the current ® Technical Manual of the ABB i-bus EIB. • Connect a PC with EIBA Tool Software (ETS2 V1.1) to the EIB via an RS232 interface.