Page 3
Thank you for choosing a first class product from Electrolux, which hopefully will provide you with lots of pleasure in the future. The Electrolux ambition is to offer a wide variety of quality products that make your life more comfortable.
Ensure a good ventilation around the appliance. A poor air supply could cause lack of oxygen. nings car nings car nings car nings carefully befor efully befor efully befor efully befor efully before installing or electrolux 5 e installing or e installing or e installing or e installing or...
Page 6
6 electrolux When using the hob for a long period time, the ventilation should be improved, by opening a window or increasing the extractor speed. Do not use this hob if it is in contact with water. Do not operate the hob with wet hands.
7 Description of the Hob 1. Hob Top 2. Semi-rapid Burner 3. Rapid Burner 4. Auxiliary Burner 5. Triple Crown Burner 6. Control knob for front left burner (semi-rapid) 7. Control knob for back left burner (semi-rapid) 8. Control knob for back right burner (triple crown/rapid)
8 electrolux Instructions for the User INST INST ALLA ALLA TION TION INST INSTALLA INST ALLATION ALLA TION TION Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered Any gas installation must be carried out by a registered...
), then push it A - Burner cap B - Burner crown C - Ignition electrode D - Thermocouple (only in models EHG 641, EHG 6412, EHG 6832) electrolux 9 Triple Crown Burner (only in mod. EHG 6832) Fig. 1...
Page 10
10 electrolux push the relevant knob down and turn it anti-clockwise until it reaches the “maximum” position. Do not keep the control knob pressed for more than 15 seconds. If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position ( ) and wait for at least one minute before trying to light the burner again.
Page 11
11 smaller smaller smaller smaller smaller than than than than than...
12 electrolux Maintenance and Cleaning Before any maintenance or cleaning can be carried out, Before any maintenance or cleaning can be carried out, Before any maintenance or cleaning can be carried out, Before any maintenance or cleaning can be carried out,...
Page 13
The electric ignition is obtained through a ceramic electrode which contains a metal electrode (Fig. 1 - C). Keep these components very clean, to avoid difficult lighting, and check that the burner crown holes (Fig. 1 - B) are not obstructed. electrolux 13...
14 electrolux Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM SYMPTOM SYMPTOM SYMPTOM SYMPTOM There is no spark when lighting the gas. The gas ring burns unevenly.
Page 16
16 electrolux WARNING WARNING – This appliance, if installed in CYPRUS and MALTA WARNING WARNING WARNING countries, does not function with the existing gas settings. Therefore, before connecting the appliance it is essential to change the nozzles according to the type of gas used (G30) following the instructions on page 30.
Domestic Gas Installation I.S. 813 Current Editions Table Four. is required. If it is installed in a room of volume an air vent of effective area of 50 cm no air vent is required. electrolux 17 an air vent of is required, and 11 m...
18 electrolux Installation IMPOR IMPOR IMPOR T T T T T ANT IMPOR IMPOR This hob must be installed by a competent person to the This hob must be installed by a competent person to the This hob must be installed by a competent person to the...
Failure to ensure the correct assembly will cause leakage of Failure to ensure the correct assembly will cause leakage of gas. gas. gas. gas. gas. electrolux 19 ectly, with the shoulder ectly ectly , with the shoulder , with the shoulder , with the shoulder...
Page 20
20 electrolux Location Location Location Location Location The hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom, shower room or garage. Ensure that there is a minimum distance of 55 mm between the rear cut out edge and the wall.
(see diagram). When the screws have been tightened, the excess seal can be removed. The edge of the hob forms a double seal which prevents the ingress of liquids. without electrolux 21 Seal Seal Seal Seal Seal...
22 electrolux Building In B B B B B uilding over a cupboard or drawer uilding over a cupboard or drawer uilding over a cupboard or drawer uilding over a cupboard or drawer uilding over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below the base of the hob on the underside of the work surface.
(shock) hazard. Ensure that the cut off plug is disposed safety (shock) hazard. Ensure that the cut off plug is disposed of safely of safely..of safely of safely of safely - Earth - Neutral - Live electrolux 23 FO 0390...
Page 24
24 electrolux The replacement of electric cable must be carried out ex- The replacement of electric cable must be carried out ex- The replacement of electric cable must be carried out ex- The replacement of electric cable must be carried out ex-...
26 electrolux Fault Finding Preliminary Electrical Systems Check Preliminary Electrical Systems Check Preliminary Electrical Systems Check Preliminary Electrical Systems Check Preliminary Electrical Systems Check S T A R T S T A R T S T A R T S T A R T...
Page 27
It is possible that a fault could occur as a result of local burning/arcing but no fault could be found under test. However a detailed visual inspection should reveal evidence of burning around the fault. electrolux 27...
Page 28
28 electrolux Ignition System / Gas Ignition Ignition System / Gas Ignition Ignition System / Gas Ignition Ignition System / Gas Ignition Ignition System / Gas Ignition Ignitor does not spark Check plug top fuse and replace if necessary Check polarity and...
The pressure reading should be nominally 20 mbar and must be between 17 mbar and 25 mbar. 4) Turn off the burner supplies. screw (see does electrolux 29 Minimum adjustment Minimum adjustment Minimum adjustment Minimum adjustment Minimum adjustment s c r e w...
30 electrolux Conversion from Natural Gas to LPG IMPOR IMPOR T T T T T ANT IMPOR IMPOR IMPOR The replacement/conversion from natural gas to LPG should only The replacement/conversion from natural gas to LPG should only The replacement/conversion from natural gas to LPG should only...
31 Standard Guarantee Conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: •The appliance has been correctly installed and used only on the gas and electricity...
Page 32
32 electrolux are subject to rental agreements. •Products of Electrolux manufacturer that are not marketed by Electrolux. Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Service Force Centre by telephoning...
• The appliance is installed and used in accordance with instructions issued by Electrolux and is only used within the home, i.e. is not used for commercial purposes. • The appliance is installed in accordance with all relevant regulations in force within your new country of residence.