Page 4
組み立て BKM-10R 底面の足 4 本を外す。 BKM-10R BKM-10R 後面のDISPLAY UNIT 端子に付属の9ピン リ モー ト ケーブル U N I T を接続し、 コネク ターのネジを締め L A Y D I S P る。 ピンリモート ケーブル BKM-10R の両側面にベースフレー ネジ ネジ ム (左) (右) を取り付ける。 各ベースフレームは、 ネジA (4× ベースフレーム...
Assembly ....................2(E) Using the Spacers ............... 5(E) Overview The BKM-34H Monitor Control Unit Attachment Kit is an assembly kit for joining a Sony BVM-D24E1W series monitor to a BKM-10R Monitor Control Unit. Components The BKM-34H consists of the following components.
Assembly Remove the four feet from the bottom of the BKM-10R. BKM-10R Connect one end of the supplied 9-pin remote control U N I T cable to the DISPLAY UNIT L A Y D I S P connector at the rear of the BKM-10R, and fasten the screws of the cable connector.
Page 11
Attach the feet removed in step 1 to the two base frames using Screw removed in step 1 the screws removed in step 1. Foot Assemble the large or small spacers to the front of the left and right base frames, using two screws B (4×8 mm, gold).
Page 12
Assembly Place the monitor on the rear stay so that the two feet of the Monitor monitor go into the two round holes on the top of the rear stay. Note When placing the monitor, be sure to hold the handles of the monitor.
Using the Spacers Two types of spacers are supplied with this unit. The front design of the monitor varies according to the spacers in use. Using the large spacers Using the small spacers Changing the spacers After the monitor and the BKM- 10R have been assembled, you can change the spacers easily as follows:...
Page 15
The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any...