Related Manuals for Toro 04482 200000001
Summary of Contents for Toro 04482 200000001
- Page 1 FORM NO. 3323-377 Rev. A MODEL NO. 04482 200000001 & UP OPERATOR S MODEL NO. 04483 200000001 & UP MANUAL ¤ 8- & 11-BLADE CUTTING UNITS ® (For Greensmaster 3200) © The TORO Company—1999, 2000...
-
Page 2: Table Of Contents
Table of Contents Page Adjusting Height-of-Cut Specifications Operating Instructions Adjusting the Cutting Unit Cutting Unit Daily Adjustments Adjusting The bedknife To The Reel Lubrication Leveling Front Roller To The Reel Greasing Bearings And Bushings Adjusting Shield Height Backlapping the Cutting Units Adjusting Top Bar Specifications straps have a replaceable roller that may be moved to... -
Page 3: Adjusting The Cutting Unit
High height-of-cut kit Part No. 99-1496 Weilhe rear roller Model No. 04488 Full front roller Model No.04496 Specifications and design are subject to change without notice. Adjusting the Cutting Units IMPORTANT: Read this operator's manual thor- ward, turn the bedknife adjusting knob clock- oughly before operating the cutting unit. -
Page 4: Leveling Front Roller To The Reel
Rotate the flange nuts (Fig 1, inset) on the top More aggressive; use on firm turf or Position 3: and bottom of the frame tab, clockwise or coun- higher height of cuts. terclockwise to raise or lower the end of the bed- Height-of-cut range: 2.4mm–21mm bar, as required. -
Page 5: Adjusting Shield Height
Adjusting the Top Bar Adjust the top bar, under the rear shield, to assure clippings are cleanly discharged from the reel area. Loosen the screws securing the top bar. Insert a 1.5mm feeler gauge between the top of the reel and the bar and tighten the screws. -
Page 6: Operating Instructions
Turn the cutting unit over (90°) and rest it on the Lower the cutting units onto a hard surface, shut rear roller and top rear tabs. Loosen the locknuts of the engine and remove the key from the igni- on the capscrews that retain the rear roller brack- tion. -
Page 7: Lubrication
9mm square stock into the splined coupling at the right end of the cutting unit. Note: Additional instructions and procedures on backlapping are available in the TORO Sharpening Reel & Rotary Mowers Manual Form No. 80-300PT.