HP b2600 Installation Manual

Hp b2600: installation guide

Hide thumbs Also See for b2600:

See also: Troubleshooting Manual , Administration Manual

Read Before Installing

The B2600 can be used as a desktop or a rack-mount system. This section covers how to convert

your system from a desktop system to a rack-mount system and from a rack-mount system to a

desktop system.

To convert your desktop system to a rack-mount system, you will need to order the rack-mount kit

(HP Part Number: A7228A) from your local HP Sales Representative. Next, follow this procedure:

1. Press in on the release buttons located on both ends of the bezel to remove it. See below

2. Remove the top and bottom plastic covers from the system by lifting up on the rear of the covers

and pulling toward you. Note that there are two plastic ridges located beneath the top and

bottom covers. These are the points where you should apply your lifting and pulling pressure.

Also the system should be placed on a soft surface to avoid scratching the system covers. See

below:

3. Note that the cover is only slightly lifted up to avoid breaking the plastic cover locks. These seven

cover locks hold the top and bottom covers to the system chassis.

Follow the instructions on the subsequent pages for rack mounting your system.

Front Bezel Removal

Removing the Top and Bottom System Covers

Table of Contents

Page 1 Read Before Installing Desktop to Rack-Mount The B2600 can be used as a desktop or a rack-mount system. This section covers how to convert your system from a desktop system to a rack-mount system and from a rack-mount system to a desktop system.
Page 6 Configuration Menu: Enter command > boot Converting Your Rack-Mount System to a Desktop System To convert your rack-mount system to a desktop system, you will need to order the desktop kit (HP Part Number (A7227A) from you local HP Sales Representative. Next, follow this procedure: Unplug the workstation and reverse the procedure in the section “Converting Your Desktop System...