Page 1
SCT71900S0 EN FRIDGE-FREEZER USER MANUAL...
Page 2
Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you’ll find everything you need to keep all your AEG appliances looking spotless and working perfectly. Along with a wide range of accessories...
CONTENTS Contents 4 Safety information 6 Control panel 9 First use 10 Daily use 13 Helpful hints and tips 14 Care and cleaning 15 What to do if… 17 Technical data 18 Installation 25 Noises 27 Environmental concerns The following symbols are used in this user manual: Important information concerning your personal safety and information on how to...
Safety information SAFETY INFORMATION In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the ap- pliance are thoroughly familiar with its operation and safety features.
– thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. WARNING! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard.
Control panel • Regularly examine the drain in the refrigerator for defrosted water. If necessary, clean the drain. If the drain is blocked, water will collect in the bottom of the appliance. Installation For electrical connection carefully follow the instructions given in specific paragraphs. •...
Control panel Press the alarm reset button. The alarm indicator light goes out and at the same time the freezer temperature indicator show for about 5 seconds the warmest temperature reached in the freezer compartment. Temperature setting buttons The temperature is adjusted using the temperature setting buttons. These buttons are con- nected to the temperature indicator.
COOLMATIC function The COOLMATIC function is suitable for quick cooling of large quantities of goods in the refrigerator. To activate the function, do these steps: 1. Press the Fridge Temperature - button (several times if necessary) until the word “SC” appears in the display.
Daily use Do not use detergents or abrasive powders, as these will damage the finish. DAILY USE Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep- frozen food for a long time. To freeze fresh food activate the FROSTMATIC function at least 24 hours before placing the food to be frozen in the freezer compartment.
Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. Cold accumulators One or more cold accumulators are supplied in the freezer;...
Page 12
Daily use 1. lift the shelf with the sliding box upwards and out of the holders in the door 2. remove the retaining bracket out of the guide under the shelf 3. Reverse the above operation to insert the sliding box at a different height. MAXIBOX drawer The drawer is suitable for storing fruit and vege- tables.
HELPFUL HINTS AND TIPS Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. • If the ambient temperature is high and the Temperature Regulator is set to low tempera- ture and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator.
Care and cleaning • water ices, if consumed immediately after removal from the freezer compartment, can possibly cause the skin to be freeze burnt; • it is advisable to show the freezing in date on each individual pack to enable you to keep tab of the storage time.
Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment ev- ery time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor com- pressor, where it evaporates.
Page 16
What to do if… There are some sounds during normal use (compressor, refrigerant circulation). Problem The appliance is noisy The appliance does not operate. The lamp does not operate. The lamp does not work. The Pilot light flashes. The buzzer sounds. The Alarm light flashing.
Problem Temperature cannot be set . The temperature in the appliance is too low/high. The temperature in the re- frigerator is too high. The temperature in the freezer is too high. Replacing the lamp The appliance is equipped with a longlife LED interior light. Only service is allowed to replace the lighting device.
Installation INSTALLATION WARNING! Read the "Safety Information" carefully for your safety and correct operation of the appli- ance before installing the appliance. Positioning Install this appliance at a location where the ambient temperature corresponds to the cli- mate class indicated on the rating plate of the appliance: Climate class Electrical Connection CAUTION!
Green and Yellow: Brown: Blue: As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the let- ter “E“...
Installation 3. Unscrew the pins (B) and spacers (C). 4. Remove the lower door. 5. Loosen the lower pin. On the opposite side: 1. Install the lower pin. 2. Install the lower door. 3. Refit the pins (B) and the spacers (C) on the middle hinge on the opposite side.
Page 21
If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. Drill the hinge cover A, as shown in fig- ure. Apply the covers A and A1 (in the acces- sories bag) in to the middle hinge. Install the appliance in the niche.
Page 22
Installation Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front- edge is 44 mm. The lower hinge cover (in the accessories bag) makes sure that the distance be- tween the appliance and the kitchen furniture is correct.
Page 23
Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. If the appliance must connect laterally to the kitchen furniture door: a) Slacken the screws in fixing brackets (H).
Page 24
Installation 10. Install the part (Ha) on the inner side of the kitchen furniture. 11. Push the part (Hc) on the part (Ha). 12. Open the appliance door and the kitch- en furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha).
13. Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the door where the nail must be fitted (K). 14. Place the small square on the guide again and fix it with the screws sup- plied.
Environmental concerns HISSS! HISSS! SSSRRR! SSSRRR! CRACK! CRACK! ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.