hit counter code
Download Print this page
GE DPSB619GD Specifications
GE DPSB619GD Specifications

GE DPSB619GD Specifications

Super 7.0 cu. ft. capacity gas dryer with stainless steel drum
Hide thumbs Also See for DPSB619GD:

Advertisement

Quick Links

Side View
dpsb619Gdww – GE profile
23-1/2
28-1/4
25-1/2*
8-1/2
Side View
5.8, 6.0 and 7.0 cu. ft. Dryers
power Cord Locations
5''
Washer/Dryers SC QSart
Power
Cord Hole
4-1/2''
Back View
specification Revised 4/06
270187

Rear View

super 7.0 Cu. Ft. Capacity Gas dryer with stainless steel drum
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
27
42
11-1/2
36
2
3-1/2
2-1/2
Rear View
Exhaust Options:
When viewed from the front of the unit, exhaust 3-way via rear, left and
bottom. Dryer is shipped exhausted to the rear. Alternate exhausting
knockouts are supplied.
Gas: An individual properly-grounded branch circuit, with a three-prong
grounding-type receptacle, protected by a 15 or 20 amp circuit breaker or a
time-delay fuse is required.
Gas dryer Electric Rating: 120V, 60Hz, 6A
Gas (bTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP
gas. LP gas supply requires a conversion kit. Check installation instructions
for correct kit and have a qualified gas technician install a conversion kit.
See dryer ducting information for proper installation.
Note: Dryer wall outlet must be located within 36" of service cord entry
and accessible when dryer is mounted in position.
Installation Information: For complete information, see installation
instructions packed with your dryer.
Listed by
Underwriters
Laboratories
For answers to your Monogram,
®
GE Profile
GE
appliance questions, visit our website at
®
GEAppliances.com or call
GE Answer Center
service, 800.626.2000.
®
or

Advertisement

loading

Summary of Contents for GE DPSB619GD

  • Page 1: Rear View

    See dryer ducting information for proper installation. Note: Dryer wall outlet must be located within 36" of service cord entry and accessible when dryer is mounted in position.
  • Page 2 Installation Requirements Alcove or Closet Installation: • If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back. • The dryer MUST be exhausted to the outside.
  • Page 3 • Five Heat Selections – Temperatures are matched to fabric type for better fabric care • Interior Dryer Light – Lets you see everything inside for easy loading and unloading • Multiple Dry Cycles, Including Custom Options – Cycles are matched to fabric type for enhanced drying performance and flexibility •...

This manual is also suitable for:

Profile dpsb619gdww