Page 2
Items Contents Dimensions ( W × H × D ) 47.0 cm × 36.70 cm × 16.0 cm [47.0 cm × 33.5 cm × 7.3 cm (Without stand)] Mass 5.6 kg [4.8 kg (Without stand)] Power Input AC220V - AC240 V, 50 Hz Power Consumption 50 W (Standby: 0.7 W) TV RF System...
SECTION 1 PRECAUTION SAFETY PRECAUTIONS (1) The design of this product contains special hardware, (6) Isolation Check (Safety for Electrical Shock Hazard) many circuits and components specially for safety After re-assembling the product, always perform an isola- purposes. For continued protection, no changes should be tion check on the exposed metal parts of the cabinet (an- made to the original design unless authorized in writing by tenna terminals, video/audio input and output terminals,...
Page 4
INSTALLATION 1.2.1 HEAT DISSIPATION 1.2.3 INSTALLATION REQUIREMENTS If the heat dissipation vent behind this unit is blocked, cooling Ensure that the minimal distance is maintained, as specified efficiency may deteriorate and temperature inside the unit will below, between the unit with and the surrounding walls, as well rise.
Page 5
HANDLING LCD PANEL 1.3.1 PRECAUTIONS FOR TRANSPORTATION 1.3.2 OPTICAL FILTER (ON THE FRONT OF THE LCD PANEL) When transporting the unit, pressure exerted on the internal LCD (1) Avoid placing the unit under direct sunlight over a panel due to improper handling (such as tossing and dropping) prolonged period of time.
SECTION 2 SPECIFIC SERVICE INSTRUCTIONS FEATURES DIGITAL TUNER PICTURE MODE This TV can receive both DVB-T (Digital terrestrial broadcasting), This function can adjust the picture settings automatically. DVB-S(Digital satellite broadcasting), and Analogue terrestrial There are BRIGHT, STANDARD, SOFT and MANUAL in the broadcasting.
Page 7
TECHNICAL INFORMATION 2.3.1 LCD PANEL This unit uses the flat type LCD (Liquid Crystal Display) panel that occupies little space, instead of using the conventional CRT(Cathode Ray Tube). This panel adopts "normally white" mode where the transmittance or reflective rate is maximum, and the screen is white when no voltage is applied.
SECTION 3 DISASSEMBLY CAUTION AT DISASSEMBLY • Make sure that the power cord is disconnected from the outlet. • Pay special attention not to break or damage the parts. • Make sure that there is no bent or stain on the connectors before inserting, and firmly insert the connectors. •...
Page 9
CORD GUIDE REAR COVER SIDE SHIELD MAIN PWB POWER UNIT MAIN SHEILD FRONT BRACKET STAND LCD PANEL BLUE LED MODULE FRONT CABINET IR PWB KEY PWB CONTROL BASE CONTROL KNOB Fig.3-1 (No.YA697<Rev.001>)1-9...
Page 10
MEMORY IC REPLACEMENT • This model uses the memory IC. • This memory IC stores data for proper operation of the video and drive circuits. • When replacing, be sure to use an IC containing this (initial value) data. 3.3.1 MEMORY IC REPLACEMENT PROCEDURE 1.
Page 11
3.3.3 SETTINGS OF FACTORY SHIPMENT 3.3.3.1 BUTTON OPERATION 3.3.3.2 REMOTE CONTROL DIRECT OPERATION Setting item Setting position Setting item Setting position POWER CHANNEL CHANNEL VOLUME VOLUME ZOOM AUTO SUB POWER 3.3.3.3 REMOTE CONTROL MENU OPERATION (1) Picture (4) Feature Setting item Setting position Setting item Setting position...
Page 12
REPLACEMENT OF CHIP COMPONENT 3.4.1 CAUTIONS (1) Avoid heating for more than 3 seconds. (2) Do not rub the electrodes and the resist parts of the pattern. (3) When removing a chip part, melt the solder adequately. (4) Do not reuse a chip part after removing it. 3.4.2 SOLDERING IRON (1) Use a high insulation soldering iron with a thin pointed end of it.
SECTION 4 ADJUSTMENT ADJUSTMENT PREPARATION (1) This TV is adjusted by using REMOTE CONTROL UNIT. (2) The adjustment using the REMOTE CONTROL UNIT is made on the basis of the initial setting values. The setting values which adjust the screen to the optimum condition can be different from the initial setting values. (3) Make sure that connection is correctly made AC to AC power source.
ADJUSTMENT PROCEDURE 4.7.1 VIDEO CIRCUIT Measuring Item Test point Adjustment part Description instrument WHITE Remote [White Balance] (1) Set COLOUR TEMP. to "Normal". BALANCE control unit Normal R (2) Enter the FACTRY MODE. Normal G (3) Press [ ] / [ ] key on the remote control unit Signal Normal B simultaneously to select the White balance.
Page 15
PARTS LIST CAUTION The parts identified by the symbol are important for the safety . Whenever replacing these parts, be sure to use specified ones to secure the safety. The parts not indicated in this Parts List and those which are filled with lines --- in the Parts No. columns will not be supplied. P.W.
Page 16
IR P.W. BOARD ASS'Y (HU-72200001) ......................3-10 KEY P.W. BOARD ASS'Y (HU-72200002) ...................... 3-10 PACKING ................................... 3-11 PACKING PARTS LIST ............................. 3-11 USING P.W. BOARD & REMOTE CONTROL UNIT P.W.B ASS'Y No. P.W.B ASS'Y name LT-19DB1BU/AX MAIN P.W.B HU-71100004 IR P.W.B HU-72200001 KEY P.W.B HU-72200002...
Page 18
PRINTED WIRING BOARD PARTS LIST MAIN P.W. BOARD ASS'Y (HU-71100004) Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local D651 HU-003100001 DIODE D1081 HU-003060190 DIODE HU-000140583 DC-DC CONV D1083 HU-0030000002 DIODE HU-000091030 LDO REGULATOR D1084 HU-003060190 DIODE...
Page 19
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C184 HU-001060250 C CAPACITOR 0.1uF 16V K C341 HU-001060297 C CAPACITOR 0.01pF 50V K C185 HU-001060250 C CAPACITOR 0.1uF 16V K C342 HU-001060297 C CAPACITOR 0.01pF 50V K C186 HU-001060250...
Page 20
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C456 HU-001060318 C CAPACITOR 0.1uF 50V C671 HU-001071190 E CAPACITOR 10uF 16V C457 HU-001060222 C CAPACITOR 4.7uF 16V C672 HU-001060219 C CAPACITOR 1000pF 50V K C458 HU-001060318 C CAPACITOR...
Page 21
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local C925 HU-001060250 C CAPACITOR 0.1uF 16V K HU-002000437 MG RESISTOR 10kΩ C926 HU-001060219 C CAPACITOR 1000pF 50V K HU-002001163 MG RESISTOR 75kΩ C927 HU-001071224 E CAPACITOR 220uF 16V HU-002000465...
Page 22
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R226 HU-002000437 MG RESISTOR 10kΩ R443 HU-002000433 MG RESISTOR 0Ω R227 HU-002000437 MG RESISTOR 10kΩ R457 HU-002000417 MG RESISTOR 4.7kΩ R228 HU-002000437 MG RESISTOR 10kΩ...
Page 23
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local R679 HU-002000502 MG RESISTOR 3.3kΩ R881 HU-002001082 MG RESISTOR 30.9kΩ R680 HU-002000527 MG RESISTOR 100Ω R882 HU-002000547 MG RESISTOR 120Ω R681 HU-002001009 MG RESISTOR 68kΩ...
Page 24
Ref No. Part No. Part Name Description Local Ref No. Part No. Part Name Description Local L383 NQR0154-002X FERRITE CORE RV522 HU-002110004 VARISTOR 100pF 5.6V L384 NQR0154-002X FERRITE CORE RV523 HU-002110008 VARISTOR L385 NQR0154-002X FERRITE CORE RV524 HU-002110008 VARISTOR L386 NQR0154-002X FERRITE CORE RV525...
Page 25
PACKING PACKING PARTS LIST Ref.No. Part No. Part Name Description Local ------------ CARTON BOX Not supply ------------ CUSHION Not supply HU-0320200064 REMOTE CONTROL UNIT RM-C2503 ------------ BATTERY AAA/R03(x2) HU-2000000111 INST BOOK English/French/German/Italian ------------ WARRANTY CARD HU-2030000021 HU-2000700105 CAUTION SHEET ------------ POLY BAG Not supply...
Page 27
LT-19DB1BU STANDARD CIRCUIT DIAGRAM NOTE ON USING CIRCUIT DIAGRAMS 1.SAFETY Type No indication : Ceramic capacitor The components identified by the symbol and shading are : Metalized mylar capacitor critical for safety. For continued safety replace safety ciritical : Polypropylene capacitor components only with manufactures recommended parts.
Page 28
KEY PWB CIRCUIT DIAGRAM ......................... 2-65 PATTERN DIAGRAMS ................2-67 MAIN PWB PATTERN ..........................2-67 IR PWB PATTERN ............................ 2-71 KEY PWB PATTERN ..........................2-71 USING P.W. BOARD P.W.B ASS Y name LT-19DB1BU/AX MAIN P.W. BOARD HU-71100004 IR P.W. BOARD HU-72200001 KEY P.W. BOARD HU-72200002...
WIRING DIAGRAM LCD PANEL UNIT [LCD CONTROL PWB] LCD PANEL UNIT JP451 CN200 KEY PWB DIGITAL TUNER (SATELLITE) DIGITAL TUNER (TERRESTRIAL) F100 250V/4A CN100 JP761 MAIN PWB POWER UNIT POWER CORD SPEAKER(L) SPEAKER(R) BLUE LED MODULE IR PWB (No.YA697<Rev.001>)2-3 2-4(No.YA697<Rev.001>)
Page 54
MAIN PWB CIRCUIT DIAGRAM (24/28) [TS Switch] TS0_DATA from TER DTT ONLY MODEL OPTION MAIN PWB (26/28) TS0_DATA[7..0] U851 SN74LVC244APWR TS0_DATA0 TSI_D0 R851 101/1005 MUX_TSI_D0 TS0_DATA0 PR851 TSI_D0 MUX_TSI_D0 TS0_DATA1 TSI_D1 R852 101/1005 MUX_TSI_D1 TS0_DATA1 OPEN-000*4/1005 TSI_D1 MUX_TSI_D1 TS0_DATA2 TSI_D2 R853 101/1005 MUX_TSI_D2...
Page 55
MAIN PWB CIRCUIT DIAGRAM (25/28) [CHANNEL POWER] DVB-T+C POWER QPSK POWER U881 LD29150PT/P-PAK 5P TP769 TP770 MAX 1.5A PCB_TP08 PCB_TP08 +3V3_TS U882 TP765 LD1117AL-ADJ +5VTA PCB_TP08 +5.03V MAX 490mA MAIN PWB (3/28) SMPS_ON C888 TP764 C884 +5V4STB PCB_TP10 C891 104p/16V/1005 R882 C892 106p/16V/2012...
Page 56
MAIN PWB CIRCUIT DIAGRAM (26/28) [OFDM Demodulator] +3V3DT +3V3DT R961 R962 OPEN-103/1005 472/1005 R963 102/1005 IF_AGC0 MAIN PWB +3V3DT IF_AGC0 TUNER0_AGC (1/28) JP961 MAIN PWB (7/28) CH_TER_RESET Near By Tuner OPEN-53014-0410 C975 C962 FLI_SCL0 104p/16V/1005 104p/16V/1005 FLI_SDA0 VDDD_3V3 VDDD_1V2 VDDDC_1V2 VDDA_3V3 R966 101/1005...
Page 57
MAIN PWB CIRCUIT DIAGRAM (27/28) [LNB Supply] C1085,1091,1092 are located near by U1081 C1085,1091,1092 are located near by U1081 +3V3_TS C1082 104p/50V/2012 R1081 C1081 103p/50V C1083 D1081 OPEN-222/1005 104p/50V/2012 SS14 R1083 220/1005 MAIN PWB (28/28) 22K_TONE D1082 OPEN-SX34 C1085 C1084 474p/50V/2012 100uF/50V/NXB +12V...
Page 64
Victor Company of Japan, Limited Display Division 12, 3-chome, Moriya-cho, Kanagawa-ku, Yokohama-city, Kanagawa-prefecture, 221-8528, Japan (No.YA697<Rev.001>) Printed in Japan...