hit counter code
Electrolux Beam Central Vacuum System Owner's Manual
  1. Manuals
  2. Brands
  3. Electrolux Manuals
  4. Vacuum Cleaner
  5. Beam Central Vacuum System
  6. Owner's manual

Electrolux Beam Central Vacuum System Owner's Manual

Hide thumbs

Advertisement

Table of Contents

Beam Central Vacuum System
Owner's Manual

Advertisement

Table of Contents
loading

Related Manuals for Electrolux Beam Central Vacuum System

Summary of Contents for Electrolux Beam Central Vacuum System

  • Page 1 Beam Central Vacuum System Owner’s Manual...

  • Page 2: Table Of Contents

    CONTENTS Introduction Maintenance Safeguards Trouble-shooting Power Unit installation Service warranty Operation & cleaning INTRODUCTION Components of Beam Central Vacuum System Congratulations on your purchase of a new Beam Central Vacuum System. It is the built-in cleaning Power Unit/Dust Collection Receptacle: appliance designed to help you clean your home Mounted in the utility room, basement or garage, it efficiently and effectively.

  • Page 3: Safeguards

    GENERAL INFORMATION The built-in vacuum system is designed for dry pick up of household dirt and dust. Avoid vacuuming up hard or sharp objects to prevent hose and plastic pipe clogs or damage. IMPORTANT SAFEGUARDS When using an electric appliance, basic precautions should always be followed, including the following: WARNING: Read All Instructions Before Using This Vacuum Cleaner.

  • Page 4: Power Unit Installation

    GROUNDING (EARTHING) INSTRUCTIONS This appliance must be grounded (earthed) and is equipped with a cord having an equipment- grounding (earthing) conductor and grounding (earthing) plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded (earthed) in accordance with all local codes and ordinances.

  • Page 5: Operation & Cleaning

    OPERATION Your central vacuum system starts and stops automatically. To turn the system on, plug the hose into a wall inlet valve. To turn it off, remove the hose from the valve. The hose handle may be equipped with an optional on-off switch. It is used to control the start and stop of the power unit while the hose is plugged into an inlet valve.

  • Page 6: Maintenance

    Cleaning tools MAINTENANCE The Beam hose and attachment set comes with Instructions provided in the booklet serve as a a telescopic wand and a variety of cleaning tools guide to routine maintenance. Proper airfl ow or allowing you to clean virtually any surface from suction can be maintained by keeping the dirt fl...

  • Page 7: Trouble-Shooting

    Filter maintenance TROUBLE-SHOOTING Beam’s exclusive fi lter is permanent and self- If you experience trouble with your central cleaning. However, if cleaning is desired, just vacuum system, follow the suggestions below follow the steps listed on the next page: before calling for service. NOTE: Disconnect power cord from electrical outlet Partial/total loss of suction power before cleaning the fi...

  • Page 8: Service Warranty

    For prompt and complete service information, always refer to these numbers when inquiring about service. DO NOT OIL THE MOTOR AT ANY TIME. IT IS PERMANENTLY LUBRICATED AND SEALED. Sold and serviced by: www.beamvac.com ©2005 Electrolux Home Care Products Ltd.

Table of Contents

Save PDF