Storing Printed Output; Setting The Paper Thickness Lever - Canon MultiPASS F60 Basic Manual
Canon multipass f60: basic guide
Hide thumbs
Also See for MultiPASS F60:
- Software user's manual (206 pages) ,
- Comprehensive manual (134 pages) ,
- Setup sheet (9 pages)
Table of Contents
Advertisement
• Images may smudge if you place them in an album before the ink is completely dry. It is
recommended that you allow the ink to dry for 24 hours.
• Do not attempt to dry the ink with a hairdryer or by exposing printed sheets to direct
sunlight.
Storing printed output
• Do not store or display printouts in hot, damp, or humid conditions. Never expose them to
heat or direct sunlight.
• Store printouts in photo albums, photo frames, or presentation binders to protect them
from direct exposure to air or sunlight.
• Do not mount printouts in an adhesive-type album as you may not be able to remove
them.
• Be aware that some types of clear plastic folders and albums may cause the edges of the
paper to turn yellow.
Setting the paper thickness lever
The paper thickness lever adjusts the gap between the printhead and the print media to suit
the print media's thickness. Before printing, be sure to set the paper thickness lever.
Follow this procedure to set the paper thickness lever:
1
Press [Open] q and lift up the scanning
unit w.
2
Move the paper thickness lever to the
appropriate setting.
• For details on which position to set for the
print media you are using, see p. 2-2.
3
Close the scanning unit until it locks into
place.
2-6
Documents and print media
w
q
Chapter 2
Advertisement
Table of Contents
