Toro 127-6818 Installation Instructions

High-lift blade and baffle kit 2013 and after timemaster lawn mower

Download this manual

High-Lift Blade and Baffle Kit

2013 and After TimeMaster Lawn Mower

Model No. 127-6818

Important: You will need a torque wrench to install the blades properly. If you do not have a torque wrench or are

uncomfortable performing this procedure, contact an Authorized Service Dealer.

Note: Determine the left and right sides of the machine from the normal operating position.

This product contains a chemical or chemicals known to the State of California to

Preparing the Machine

No Parts Required

Procedure

1. Lock the handle in the vertical position (Figure 1); refer

to Adjusting the Handle Height in the Operator's Manual.

1. Handle locked in the vertical position

8111 Lyndale Avenue South

Bloomington, MN 55420

Proposition 65 Warning

cause cancer, birth defects, or reproductive harm.

G016519

Figure 1

WARNING

CALIFORNIA

2. Tip the machine onto its side, with the dipstick down,

until the upper handle rests on the ground.

WARNING

The blades are sharp; contacting a blade could

result in serious personal injury.

• Disconnect the wire from the spark plug.

• Wear gloves when servicing the blade.

Form No. 3378-969 Rev A

Installation Instructions

Original Instructions (EN)

Printed in the USA

Page 1 Form No. 3378-969 Rev A High-Lift Blade and Baffle Kit 2013 and After TimeMaster Lawn Mower Model No. 127-6818 Installation Instructions Important: You will need a torque wrench to install the blades properly. If you do not have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service Dealer.
Page 2 Removing the Existing Blades Installing the Baffle No Parts Required No Parts Required Procedure Procedure 1. Use a block of wood to hold each blade steady, and turn 1. Remove the 4 bolts and 4 nuts in the front of the the blade bolt counterclockwise as shown in Figure 2.
Page 3 Installing the High-lift Blades No Parts Required Procedure 1. Install the first blade so that it is horizontal, along with 6536 all mounting hardware as shown in Figure 3. Figure 6 Note: Tighten the bolt with your fingers. 1. Blade (2) Important: Position the curved ends of the blades to point toward the machine housing.