Related Manuals for Toro RP-1200D
Summary of Contents for Toro RP-1200D
- Page 1 Form No. 3383-608 Rev A RP-1200D and RP-1400D Reversible Plate Compactor Model No. 68074—Serial No. 313000001 and Up Model No. 68075—Serial No. 313000001 and Up *3383-608* A Register at www.Toro.com. Original Instructions (EN)
-
Page 2: Introduction
This manual identifies potential hazards and has safety messages identified by the safety alert symbol (Figure 2), You may contact Toro directly at www.Toro.com for product which signals a hazard that may cause serious injury or death and accessory information, help finding a dealer, or to register if you do not follow the recommended precautions. -
Page 3: Table Of Contents
Contents Safety Improper use or maintenance by the operator or Introduction ..............2 owner can result in injury. To reduce the potential Safety ................3 for injury, comply with these safety instructions and Safe Operating Practices........... 3 always pay attention to the safety alert symbol, which Safety and Instructional Decals ......... - Page 4 To best protect your investment and maintain optimal performance of your Toro equipment, count on Toro genuine parts. When it comes to reliability, Toro delivers replacement parts designed to the exact engineering specifications of our equipment. For peace of mind, insist...
-
Page 5: Safety And Instructional Decals
Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. 117–2718 125–8206 1. Caution 3. Read the Operator’s Manual for information on lifting the machine. - Page 6 125–4963 1. Warning—keep hands away from hot surfaces 125–8182 1. Slow 3. Fast 2. Variable speed control 125–4943 1. Warning—read the Operator’s Manual. 4. Choking hazard—do not operate the machine indoors. 2. Warning—wear hearing protection. 5. Explosion hazard—stop the engine and extinguish all flames before refueling the machine.
-
Page 7: Setup
Setup Product Overview Checking the Engine-Oil Level The machine comes from the factory with oil in the engine crankcase; however, it may be necessary to add oil. Refer to Checking the Engine-Oil Level (page 8). Add only enough oil to raise the level to the Full mark on the dipstick. Checking the Eccentric-Oil Level The machine comes from the factory with eccentric oil in the... -
Page 8: Controls
(Model 68075 only) 2. Fuel tank 6. Dipstick 3. Recoil-start handle 7. Start switch (Model 68075 only) 4. Engine-shutoff switch Specifications Model number RP-1200D RP-1400D Figure 5 Length 142 cm (55.9 150 cm (59 inches) 1. Pull-start temperature 2. Electric-start temperature inches) -
Page 9: Checking The Water Trap
4. As soon as diesel fuel emerges, tighten the water-trap bolt. 5. Dispose of the water and the fuel according to environmental regulations. Cleaning Debris from the Machine Service Interval: Before each use or daily 1. Set the throttle to slow, stop the engine, and wait for all moving parts to stop. -
Page 10: Adding Fuel
Adding Fuel Diesel Fuel Specifications Important: Do not mix oil with diesel. • The engine runs on clean, fresh ultra-low sulfur diesel fuel with a minimum cetane rating of 40. Use ultra-low sulfur diesel fuel that complies with the • Purchase fuel in quantities that can be used within 30 days following specification. -
Page 11: Starting And Stopping The Engine
Figure 9 1. Fuel cap 3. Red ring 2. Inlet fuel screen Figure 11 4. Add diesel to the fuel tank. (Figure 10). 1. Throttle control (slow 2. Throttle control (fast position) position) Important: Do not overfill the fuel tank. 2. -
Page 12: Operating The Compactor
Operating the Compactor Controlling the Direction of Travel • Move the travel-control handle forward to drive the machine forward (Figure 15). Figure 13 1. Engine-run light 4. Engine-temperature light 2. Battery-charge light 5. Engine-preheat light 3. Oil-pressure-warning light 6. Key Figure 15 3. -
Page 13: Maintenance
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 25 hours • Check the engine oil level. • Check the water trap. Before each use or daily • Clean debris from the air-cleaner housing. •... -
Page 14: Replacing The Fuel Filter
Figure 18 1. Knurled nut 2. Air-filter cartridge 4. Inspect the paper element, and replace air-filter cartridge if the element is damaged or excessively dirty. Note: Never try to brush dirt off the paper element; G024104 brushing forces the dirt into the fibers. 5. -
Page 15: Servicing The Engine Oil
Servicing the Engine Oil Crankcase Capacity: RP-1200D – 1.1 liter (37 oz ) Crankcase Capacity: RP-1400D – 1.5 liter (50.7 oz) Oil type: API CD, CE, CF, CF-4, CG-4 or higher Refer to the table below to determine the correct oil viscosity... -
Page 16: Servicing The Eccentric Oil
Cleaning the Oil Filter Servicing the Eccentric Oil Service Interval: Every 1,000 hours Oil capacity: 0.5 liter (6.9 oz ) 1. Drain the engine oil; refer to Changing the Engine Oil Oil Type: Detergent oil (API service SJ or higher) (page 15). -
Page 17: Servicing The Battery ( Model 68075 Only)
Changing the Eccentric Oil Servicing the Battery ( Model 68075 only) Service Interval: Yearly Every 300 hours Checking and Cleaning the Battery 1. Move the machine to a level surface. 2. Set the throttle to slow, stop the engine, and wait for Service Interval: Every 100 hours—Check the battery cable connections. -
Page 18: Servicing The Belt
4. Remove the battery. Note: Recycle the old battery at an authorized facility. 5. Place the new battery in the tray. 6. Install the positive (red) battery cable to the positive (+) battery terminal, and tighten the nut onto the bolt. 7. -
Page 19: Storage
Storage 1. Stop the engine. 2. Remove dirt and grime from the entire machine. Important: You can wash the machine with mild detergent and water. Do not pressure wash the machine. Avoid excessive use of water, especially near the engine. 3. -
Page 20: Troubleshooting
2. The oil level in the eccentric housing 2. Check the oil level and drain as is too high. necessary. 3. The clutch is slipping. 3. See your authroized Toro service dealer. 4. The engine speed is not reaching full 4. See your authroized Toro service rpm. - Page 21 Notes:...
- Page 22 Notes:...
- Page 23 Notes:...
- Page 24 Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company. Australian Consumer Law: Australian customers will find details relating to the Australian Consumer Law either inside the box or at your local Toro Dealer.