hit counter code

White Level Adjustment; Hinge Pressure Adjustment - Canon F1 Service Manual

Duplex color image reader
Hide thumbs Also See for F1:
Table of Contents

Advertisement

5
Adjustments > Adjustment Method > Hinge Pressure Adjustment

White Level Adjustment

1) Set A4 or LTR paper on the copyboard glass and close the DADF.
CAUTION:
If the paper with narrow width is used for white level adjustment, the adjustment may
not be complete properly.
2) Execute the service mode item.
Lv.
COPIER > FUNCTION > CCD >
1
DF-WLVL1
T-5-50
3) Remove the paper from the copyboard glass and set it to the original pickup tray of DADF.
4) Execute the service mode item.
Lv.
COPIER > FUNCTION > CCD >
1
DF-WLVL2
T-5-51
5) Set the paper to the copyboard glass again and close the DADF.
6) Execute the service mode item.
Lv.
COPIER > FUNCTION > CCD >
1
DF-WLVL3
T-5-52
7) Remove the paper from the copyboard glass and set it to the original pickup tray of DADF.
8) Execute the service mode item.
Lv.
COPIER > FUNCTION > CCD >
1
DF-WLVL4
T-5-53
5
Adjustments > Adjustment Method > Hinge Pressure Adjustment

Hinge Pressure Adjustment

1) Open the DADF and measure the lowest position where the DADF opens by itself.
2) Check that the height of the position measured in step 1) is within the standard.
Standard: 55 mm to 190 mm (angle: 7.5 degrees to 20 degrees)
3) If it is not within the standard, make the following adjustment.
If it is lower than 55 mm, turn the hex wrench counterclockwise.
If it is higher than 190 mm, turn the hex wrench clockwise.
Note:
Service tool: hex wrench (10 mm)
55 to 190 mm
55 to 190 mm
5-22
Hex wrench
F-5-31
5-22

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents