Table of Contents
Advertisement
Chapter 4
Address type
Manual address
Stateful address
IPv6 address confirmation from a Windows Vista PC
The following instructions pertain to communication confirmation procedures with an IPv6 link local address with a Windows Vista PC and the unit, in a network
environment with no DHCPv6 server or router.
On the unit's touch panel, use an IPv6 automatically obtained link local address to confirm the communication status.
From Additional Functions, go to System Settings > Network Settings > TCP/IP Settings > IPv6 Settings > Use IPv6
Set Use IPv6 to ON.
To change the status from OFF to ON, the unit needs to be rebooted.
Make a note of the link local address in order to input the address from a Windows Vista PC.
E.g. fe80::200:85ff:fead:bac2
4-12
Touch panel location
Settable
addresses
Manual settings
0-1
Uses DHCPv6
0-1
Address
Usage conditions
characteristics
The following addresses cannot be registered.
- Multi-cast addresses [1111 1111]- Addresses comprising all 0 [0000
0000]
- IPv4-compatible IPv6 addressesAddresses in which the upper 96 bits are
0 and the lower 32 bits are in IPv4 address hexadecimal notation.
E.g. [0::1C10:0120] Addresses used when IPv6 and IPv4 are using an
IPv6 environment.
-IPv4 -mapped addressesAddresses in which the upper 80 bits are 0, the
following 16 bits are 1 and the lower 32 bits are in IPv4 address
hexadecimal notation.
E.g. [0::FFFF:1C10:0120] Addresses used when IPv4 is using an IPv6
environment.
Begins with ff02 DHCPv6 required
F-4-28
F-4-29
Advertisement
Table of Contents
