Table of Contents
Advertisement
Item
Description
5
Maximum memory speed
6
CAS latency
7
DIMM type
For more information about product features, specifications, options, configurations, and compatibility, see the
product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
Installing a DIMM
For information about memory support, configurations, or population guidelines, see "DIMM population
information on page 89."
Prerequisites
Before installing this option, be sure that you have the following:
•
T-10 Torx screwdriver
•
The components included with the hardware option kit
Procedure
1.
Power down the server (Power down the server on page 38).
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack (Extend the server from the rack on page 38).
•
Remove the server from the rack (Removing the server from the rack on page 39).
4.
Remove the access panel (Removing the access panel on page 40).
5.
If installed, do the following:
a. Remove the air baffle (Removing the air baffle on page 42).
b. Remove the processor mezzanine tray (Removing the processor mezzanine tray on page 47).
c. Remove the 2P pass-through performance board (Removing the 2P pass-through performance
board on page 48).
6.
Open the DIMM slot latches.
7.
Install the DIMM.
90
Installing a DIMM
Definition
2133 MT/s
2400 MT/s
2666 MT/s
P = CAS 15-15-15
T = CAS 17-17-17
U = CAS 20-18-18
V = CAS 19-19-19 (for RDIMM, LRDIMM)
V = CAS 22-19-19 (for 3DS TSVLRDIMM)
R = RDIMM (registered)
L = LRDIMM (load reduced)
E = Unbuffered ECC (UDIMM)
- Quick Links:
- Power Supply Leds
Hide quick links:
Advertisement
Table of Contents
