Adjusting The Overlap Of The Sensor Flag - Toshiba e-studio200l Service Handbook
Hide thumbs
Also See for e-studio200l:
- Service manual (708 pages) ,
- Repair manual (136 pages) ,
- Service handbook (758 pages)
Table of Contents
Advertisement
3.12.3
Adjusting the overlap of the sensor flag
If the overlap between the sensor and the flag is wrong for some reason, perform the following adjust-
ment.
<Procedure>
(1)
Remove the processing tray unit.
(2)
Loosen the mounting screw of the front/rear
jogging plate adjusting plate; then, move the
adjusting plate to the left and the right.
(3)
Tighten the screw so that the overlap
between the flag of the front/rear jogging
rack plate and the sensor is 1.5 mm to 2.0
mm.
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
ADJUSTMENT
Jogging plate
adjusting plate
Adjusting
plate
Screw
Sensor
1.5 mm to 2.0 mm
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
3 - 88
Screw
Jogging plate
Adjusting
adjusting plate
plate
Fig. 3-116
Sensor flag
Fig. 3-117
- Quick Links:
- Error Code and Self-Diagnostic Mode
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
