Table of Contents
Advertisement
Fan Assembly
Description
Fan
The fan assembly is attached to the inside floor of the chassis using two screws. The fan is inside of a
removal metal cage.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the fan cable from the system board connector labeled SYS_FAN.
5.
Remove the Torx screw that secures the left side of the fan to the computer.
6.
Cut the plastic tie (1) that secures the fan cable to the power supply power cables.
7.
Remove the two screws (2) that secure the fan to the computer. The screw near the computer
side is not shown in the following image.
8.
Lift the fan assembly up and out of the computer (3).
Figure 8-31
122 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis
(Access Panel on page
(Front Bezel on page
Removing the fan
(Preparation for Disassembly on page
95).
97).
Spare part number
656834-001
94).
Advertisement
Table of Contents
Troubleshooting
