Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > NETWORK
SIPREGPR
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Additional Functions
Mode
PRCLTYPE
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
VLAN-SW
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
FTPMODE
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Setting of registrar server use protocol
To set the protocol used for communication with registrar server.
Although the protocol that is the same as the one for proxy server is usually used, another protocol
can be used in accordance with user and environment.
Upon user's request (to use a protocol different from the one for proxy server)
Enter the setting value, and then press OK key.
0 to 3
0: Protocol set in Settings/Registration menu, 1: UDP, 2: TCP, 3: SSL
0
Preferences> Network> TCP/IP Settings> SIP Settings> Intranet Settings
Setting of dedicated protocol type
To set the type of dedicated protocol (CPCA protocol).
When 1 is set, only the commands where security has been improved are accepted, whereas
conventional commands are rejected.
Upon user's request (for customization)
- Job assignment from Print/Scan/Fax driver at department management
- AiRFAX transmission job assignment
- Setting/changing of system administrator function from a remote utility such as iWEMC
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
With TYPE 1, compatibility with conventional drivers and iW products may be lost.
0 to 1
0: TYPE 0 (Compatible in a conventional manner), 1: TYPE 1
0
ON/OFF VLAN participation packets send
To set whether to send packets for participating in dynamic VLAN at link-up.
When participating in dynamic VLAN
Enter the setting value, and then press OK key.
0 to 1
0: OFF, 1: ON
0
- VLAN (Virtual LAN): A method for realizing grouping of terminals depending on the hub, switch
connection port, MAC address, protocol, etc.
- At link-up: At startup, when LAN cable is connected, when recovering from deep sleep, when
pressing the button to reflect the setting (dynamic update)
- If IP address of the machine has not been set, an IP address is assigned after participating in
VLAN.
Set of FTP print default operation mode
To set the default operation mode of FTP print.
Switch the default operation mode between ASCII mode and BIN mode in accordance with user's
environment.
Depending on the client application, FTP print becomes available without executing BIN command.
At installation
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: ASCII mode, 1: BIN mode
0
755
8. Service Mode
Advertisement
Table of Contents
Troubleshooting
